Model #80-2407-41 Laser computer

  • Replacement Parts
    3 Results

Question and Answers

Q:

Kenmore 80 Series Washer - How do I remove the control panel? 110-24872300 (Type 111)

A:

Thank you for your question and I understand your concern.

In order to place the control panel in the service position you will need to first disconnect the power cord from the power source.

Remove the left and right end cap covers. See image below. The top of the end cap covers must be pried up a little to clear the end cap and then pivot the end cap cover towards the front of the washer to remove. Once the end cap covers have been removed, you will see a screw at the bottom of the left and right hand caps. Remove the screws and then slide the control panel towards the front of the washer and lift it up and hinge it over the rear panel.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
February 14, 2013
Q:

Part 41 on Model 119.214000

A:

Thank you for your question on the slide for the band saw.

This is a plastic blade guard.

It is there for safety reasons to protect you fingers from possible getting cut by the blade if you adjusted the blade guide up and down while the saw was running.

I would suggest replacing it since it is not very expensive and it is in place as a safety guard.

Slide for band saw .

I hope this information will help.

Sam A.

Read More
Sam A -
Sears Technician
October 25, 2011
Q:

My LG 795lmx25964st will not chill below 41.

A:

Check your settings to make sure that you have that refrigerator temperature set properly.

Make sure that you do not have anything blocking the supply air vents on the back wall inside the refrigerator.

You can try to resolve this problem by resetting the control boards. Unplug the refrigerator to completely disconnect electrical power for 3 minutes. Plug the refrigerator back in. Check to see if the refrigerator cools normally.

If that does not help, then you may need to have a service technician diagnose and repair this failure. Here is a link for the Sears Service website: Sears Home Services .

If you want to conduct some more advanced troubleshooting for this problem, then you can use the information in the first image below. That image shows how to check the resistance of the refrigerator thermistor (temperature sensor) from the main control board on the back of the refrigerator. The second image shows a wiring diagram for the refrigerator. The third image shows a photograph of the main control board and how to access that microcomputer on the outside back wall of the refrigerator. Be sure that you unplug the refrigerator before accessing internal components. The 4th image shows the actual location of that thermistor in the top of the refrigerator. This information should help you further troubleshoot this cooling failure on your own. If you need more assistance with that troubleshooting, reply with additional details.

You can order parts from the Sears PartsDirect website if necessary.

NOTE: A defrost problem could be inhibiting air flow to the refrigerator. Other component problems could also be preventing the refrigerator from cooling properly. Let us know if you need more help resolving this cooling issue in your refrigerator.

Read More
Lyle W -
Sears Technician
December 14, 2011
A:

Here is the 4th image.

Read More
Lyle W -
Sears Technician
December 14, 2011
See more answers