Model #80200 TO 80299 (9010 - 9911) Briggs & Stratton engine

  • Replacement Parts
    3 Results
  • Rewind Starter Assembly
    3 Results
  • Carburetor Assembly
    3 Results
  • Air Cleaner Assembly
    3 Results
  • Wind-up Starter Assembly
    3 Results

Question and Answers

Q:

Test 9010

A:

Test.

Read More
Lyle W -
Sears Technician
February 04, 2013
Q:

Why am I STILL unable to install water filter 9010 in my Kenmore refrigerator?

A:

There should be no reason that the old filter cannot be installed back into the refrigerator since it was just removed. The new filter is apparently different but can be installed in the same manner as the previous one. I provided the instructions for removing and replacing the filter in the image below. Be sure that you are closely following these instructions. If you did not remove the front grill, I recommend removing it and trying to install the filter again. Try shifting the filter to various positions so that you can get it to full insert into the back of the housing and then turn it the 1/4 turn.

We do not have a display for this new type of filter. We are in the process of obtaining the new type of this filter so that we can physically try inserting it in the filter housing ourselves. If we encounter any problems with the filter fitting properly, we will contact the manufacturer and I will revise this answer.

Read More
Lyle W -
Sears Technician
September 03, 2009
Q:

How do I get the 9010 water filter into my Kenmore side-by-side refrigerator far enough so that the cover will lock?

A:

The instructions on changing the filter are shown in the image below. You may need to use a pair of channel lock pliers cushioned with a rag if the filter is too hard to turn by hand. On subsequent filter changes, it should get easier to turn.

Read More
Landell -
Sears Technician
February 16, 2010