Model #79640512900 Kenmore Elite residential washers

  • Cabinet And Control Panel Assembly Parts
    3 Results
  • Drum And Tub Assembly Parts
    3 Results
  • Dispenser Assembly Parts
    3 Results

Question and Answers

Q:

Is water in detergent dispenser normal?

A:

Hi Debbie,

Thank you for submitting a question to Manage My Life.

I understand your concern about having water left in the detergent dispenser. I have found a previous answer to a similar question please Click Here to view this answer. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
May 05, 2011
Q:

No Power Kenmore Washer

A:

Thank you for your question and I understand your concern.

The first thing to check and confirm is the voltage supply at the wall receptacle. You can plug some other type of appliance in the outlet to see if it works. If it works, it should not be too difficult to locate where the "pop" sound came from. Since it made a "pop"; there should be evidence of darkened or burnt component on one of the control boards. It could have been the PCB (power control board", filter board assembly, or the display board. I suggest calling a service technician to diagnose and repair your washer. You could also disconnect the power cord from the power source and then remove the top panel and make visual inspection of all the wires and control boards for any signs of a burnt wire or any darkened area on any of the control boards.

To remove the top panel you will need to remove the two screws on the back of the top panel and then pull the top backwards and upwards to remove.

You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 06, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show