Model #79551026010 Kenmore side-by-side refrigerator

  • Freezer Door Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Compartment Parts
    3 Results
  • Refrigerator Compartment Parts
    3 Results
  • Ice And Water Parts
    3 Results
  • Mechanical Parts
    3 Results
  • Dispenser Parts
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

refrig mod#79551026010 no cubed ice crushed ok water disp ok

A:

That type of failure could be caused by a failed solenoid in the dispensing system, a bad control board or a wiring harness connection problem. Since the dispenser works in the cubed setting, most of the components in that system are apparently okay. I recommend that you unplug the refrigerator and check the wire harness connection in the back of the freezer that goes to the cube solenoid. The first image below shows the cube solenoid as KEY 614A. The image beside that parts diagram shows a photograph of that wiring harness. If the connection is okay, you can check the resistance of that cube solenoid using a volt/ohm meter (with the refrigerator still unplugged ). If that cube solenoid is outside the resistance range shown below, it will need to be replaced. You can order parts from the Sears PartsDirect website. The part number for that solenoid is 6421JA3001Y.

If that solenoid is okay, you could have a problem with that display control board on the front of the dispenser or the main control board on that back of the refrigerator. A wiring failure in that solenoid circuit could also cause this problem. I recommend that you have a service technician diagnose and repair this failure if the cube solenoid is okay. Here is a link for the Sears Service website: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 03, 2011