Model #79099013102 Kenmore Elite free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

how to install burners on this model 79099013102 Kenmore Elite Sears/electric range

A:

Thank you for your question and I understand your concern.
 
To access and replace the radiant surface burners will require disconnecting the range from the power supply. The top will need to be hinged open enough to access the radiant burners once the screws located under the front of the top have been removed. See image below.
 
I added an image below with the procedure for accessing the radiant burners.
 
 
I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
August 15, 2013
Q:

I have a Kenmore range model 79099013102. I get an F1 error any time I try to use the keypad.

A:

Thank you for your question and I understand your concern.

The "F1" fault generally implies the electronic oven control (EOC) is faulty. It could however have a faulty oven temperature sensor but not likely. I added an image below with some additional information. You could disconnect the oven temperature sensor and check the resistance with an Ohm meter and compare the resistance measurement to the RTD scale. At room temperature the sensor should measure approximately 1100 Ohms of resistance. If it measures approximately 1100 Ohms, replace the electronic oven control.

This may be the issue. If not, please reply and I will be glad to assist you further.

Read More
Joey S -
Sears Technician
January 26, 2012

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show