Model #79096213403 Kenmore free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

My electric oven's baking function has quit model 79096213403. broiling/cooktop is working. No codes. any suggestions? Anyone got a wiring diagram/schematic?

A:

The wiring diagram for your range is shown in the image below. Since the broiler works, your failure is in the bake element, the control board or the wiring traced in red on the diagram. I recommend that you unplug the range and measure the resistance of the bake element with a volt/ ohm meter. You should measure about 20 ohms of resistance through this component. If it measures Ol -- Open Load (or infinite resistance) then the element is bad and will need to be replaced. If the element is okay, I recommend that you check the resistance through the circuit (BK to L2 OUT) at the connection to the control board. If the resistance through this circuit is the same as the element (about 20 ohms) then you will likely need to replace the electronic oven control board (part 316452310). You may also need to replace the overlay if you cannot reuse the one off of the original control board. You can order parts from the Sears PartsDirect website.

If you need more help, submit more details regarding your failure and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 14, 2010
Q:

Check or replace stovetop element

A:

Thank you for your question and I understand your concern.

The left front surface element could be faulty or it may have a faulty burner switch or simmer select board.

I added images below of the wiring diagram and instructions on removing the top. There should be 220 volts present across H1 and H2 at the burner switch when the burner switch is turned to high. Terminals P2 and P3 must also be made at the simmer switch too in order to complete the L2 path of voltage to the element.

I do not recommend checking voltage unless you have experience and feel safe and confident in doing so; otherwise I recommend calling a service technician to diagnose and repair your range.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 29, 2011

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show