Model #7909611240D Kenmore free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results

Question and Answers

Q:

I have a fault code on the display of my Kenmore range.

A:

Thank you for your question and I understand your concern.

The "F10" fault code indicates a runaway oven temperature. This can be caused by faulty oven temperature sensor probe or a faulty EOC (electronic oven control).

The oven temperature sensor probe should be removed and disconnected and measured for proper resistance with and Ohm meter. The oven temperature sensor probe is located inside the oven cavity in the upper rear left or right hand corner.

The oven sensor should measure approximately 1100 ohms at room temperature. If it does measure approximately 1100 Ohms, replace the electronic oven control. To access and replace the electronic oven control, disconnect the power supply from the range and the remove the panel from behind the control panel. The control is fastened with 4 screws. Make a note of where the wires connect before removing the wires from the faulty control.

I added a YouTube video showing how to test the sensor and how to access the sensor. You may be able to remove the sensor from inside the oven cavity if the two screws are visible from inside the oven.

You can look up and order the faulty part at Sears PartsDirect .

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
April 26, 2012
Q:

Kenmore electric range Getting Error Codes!

A:

That F13 error code indicates that the clock control board (part 316557118) is bad. You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Clock Timer . Here is a link for a video that shows how to replace that component: Range Clock Control Replacement . Note: You may also need the overlay for that clock (part 316419110 for the white color) unless you can reuse the original one as shown in that video. Be sure that you unplug the range before accessing and replacing internal components.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
January 30, 2012

Recommended maintenance parts & accessories

Show 3 more
No more item to show