Model #79095393903 Kenmore free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results

Question and Answers

Q:

Error Code F13 & constant beeping, on electric range #79095393903 won't reset. How can I be sure it is the EOC #316419109 that needs replacement, plus, is

A:

Thank you for your question on the replacement of the EOC.

According to the diagnostic chart the EOC needs to be replaced.

Have you disconnected the power and waited 5 minutes and plugged it back in.

If it does not come back you are ok.

If it does come back you will need to replace the EOC.

You should not have to replace the touch pad.

Remove power to the range.

Pull the range out from its location and remove the upper back panel for the control area.

Locate the EOC in the center of the control panel and remove the four screws to remove the control from the control panel.

Unlock the connector for the ribbon strip to the touch pad and carefully remove the strip from the old control.

With the new control in hand replace all the connectors one at a time until your have connectors off the old control onto the new control.

Carefully install the touch pad ribbon strip into the unlocked connection on the new control with bending any of the connections and then relock the ribbon connector. Install the new control back into the control panel and restore the back panel to the range and check operation.

I hope this will help.

Sam A.

Read More
Sam A -
Sears Technician
December 13, 2011

Recommended maintenance parts & accessories

Show 3 more
No more item to show