Model #79094352700 KENMORE free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results

Question and Answers

Q:

I need the name of a part.

A:

Thank you for your question and I understand your concern.

The "F10" fault code can display if the oven has a faulty temperature sensor probe or if the control detects a runaway temperature. I added an image below with the explanation of the "F10" fault code.

If the oven is overheating, disconnect the power supply. If the oven continues to overheat when power is reapplied, the Electronic Oven Control (EOC) will need to be replaced.

I recommend removing and disconnecting the oven temperature sensor and checking the resistance of the sensor with an Ohm meter first. The oven temperature sensor should measure approximately 1100 ohms at room temperature. If it measures around 1100 Ohms then I would suspect a faulty oven control board.

The oven temperature sensor is part #316490000 and it will cost approximate $15.00 and the Electronic Oven Control (EOC) is part #316557108 and will cost approximately $126.00. There is an overlay too that you will need to replace and it's part #316419110 and it costs approximately $24.00. The overlay will stick on the face of the EOC. The parts can be ordered from Sears PartsDirect

I added a YouTube video showing how to replace the oven temperature sensor probe .

Read More
Joey S -
Sears Technician
August 19, 2011
Q:

I have a range 79094352700.while cooking it trips the circuit and shuts the whole electric to the stove .i have checked the house and it is not the house.

A:

Thank you for your question and I understand your concern.

The problem is not likely the range if it does not trip one of the two circuit breakers as soon as the oven or surface elements are turned. If it does not trip one of the two house circuit breakers dedicated for the range as soon as the oven the oven is turned on or the radiant surface elements, then one of the two house circuit breakers is likely getting weak or the electrical supply wires are too small to handle the current.

The only way to know if the breaker(s) are weak and tripping off will require checking the amperage draw on line one (L1) and line two (L2) with an amperage meter.

The range should be connected to a 40 amp service if the model and serial number tag indicates the K.W is between 7.9-12.5 KW. If the KW (kilowatts) rating on the tag is 12.6-18.5 the range needs a 50 amp service. If L1 or L2 is pulling less than 20 amps and the breaker trips, this would indicate weak circuit breakers dedicated for the range.  

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.

 

Read More
Joey S -
Sears Technician
November 22, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show