Model #79094322300 Kenmore free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

Sears Kenmore range just popped while on and lost all electricity to my house. got the breaker back on, but the range does not work now. Model 790-94322300

A:

Thank you for your question and I understand your concern. What you’re telling me concerns me and you should call an electrician and have your electrical service inspected.

The range should be on a 50 amp dedicated protected circuit and when it popped, it shouldn't have caused the whole house to loose electricity unless it caused the main two breakers to trip.

When the range popped and/or shorted to cabinet ground it should not have cause the whole house to loose electricity. It should have tripped one or both circuit breakers dedicated for the range and not cause the whole house to loose electricity.

You didn't state if you checked and reset any other circuit breakers. The range should have its own two (2) circuit breakers inside one of circuit breakers inside or outside the house that will likely need to be reset. If the clock/oven control will not power up after resetting the two circuit breakers dedicated for the range then the voltage supply will need to be checked where the power cord is attached to the terminal block on the back of the range. NOTE: I do not recommend checking and confirming the voltage supply unless you have experience and feel safe and confident it doing so, otherwise I recommend calling a service technician to diagnose and repair your range.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 15, 2011
Q:

kenmore oven not working

A:

Thank you for your question and I understand your concern.

It's likely an electronic oven control failure. To be certain you could disconnect the power supply from the power source and remove and test the bake and broil elements. I added a YouTube video showing how to test the bake and broil elements for continuity. If the bake and broil elements tests Okay, the electronic oven control has most likely failed. I do recommend checking for any burnt wire connections at the electronic oven control and at the terminal block where the power cord attaches. If no burnt wires are found, replacing the electronic oven control should repair your oven operation.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 17, 2012