Model #79091063700 Kenmore free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results

Question and Answers

Q:

no oven heat or broil clicking noise model # 79091063700

A:

Thank you for your question and I understand your concern.

If the surface elements work and neither the bake or broil element will heat; I must assume the Electronic Oven Control has failed. The Electronic Oven Control (EOC) is part #316455420 which can be ordered from SearsPartsDirect .

The Oven control/clock can easily be removed and replaced from the back of the control panel. NOTE: Disconnect the power cord from the power source before removing the panel from behind the console.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 16, 2011
Q:

I have a Kenmore electric range, timer, clock, oven and broiler settings work. Oven does not heat . What is the name & specific part needed. 79091063700.

A:

To determine the failed part, I recommend that you perform a few checks. The wiring diagram for the oven circuit is shown in the image below. That link for a previous answer that Barbara posted in the above response describes some basic tests that are necessary to diagnose your failure on a similar model of range. Your oven circuit does not have a thermal fuse. I recommend that you check the wiring connections on the back of the control board in the console first. Unplug the range and remove the back panel behind the console to access those wiring connections on the back of the electronic oven control board. Make sure that the red and orange wires are properly connected to the control board. You can measure the resistance through the bake and broil circuits using a volt/ohm meter. The bake circuit can be checked through the yellow and orange wires. The broil circuit can be checked through the blue and orange wires. You should measure between 10 and 40 ohms of resistance through each of those circuits. If those circuits are okay, then your failure is in the wiring or the control board. If you are comfortable with making some live voltage checks, then you can check the incoming voltage the control board through the black and red wires. Note: Use extreme caution when checking that live voltage. Wear electrical safety gloves and safety goggles. Unplug the range as soon as live testing is completed . If you have the proper incoming voltage on the black and red wires, then you can check for outgoing voltage in the bake circuit through the yellow and orange wires in the bake mode. You can check the broil circuit voltage in a similar manner through the blue and orange wires. If you are not getting the proper voltage out of that control board then that component (part 316455420) will need to be replaced. I recommend that you replace the overlay (part 316220712) at the same time. You can order those parts from this page: Kenmore Range Model Parts . Be sure that you unplug the range before accessing internal components and replacing parts.

I hope that these tips help. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 10, 2012