Model #79046374401 KENMORE ELITE Slide-In Range, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers


How do I replace the left front dual-element on my Kenmore range?


You will have to diagnose which has failed, the dual radiant burner or the burner switch. I added the wiring diagram of the left front burner and instructions in the image below. The failure could be the switch or the dual radiant burner. You will need a volt/ohm meter in order to test the burner switch. First, Disconnect the range from the power source before opening the console. Disconnect the wire connected on the P2 terminal and #4 terminal. Turn the switch on so that the inner coil would come on. Place the ohm meter on Ohm’s and place one meter lead on the #4 terminal and one meter lead on the P2 terminal. If the meter shows continuity the switch is OK, replace the element. If the ohm meter shows no continuity, replace the burner switch. See image below for left front burner circuit and instructions on how to open the console and on removing the top if you have to replace the element. NOTE: Disconnect the range from the power source before servicing.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
October 20, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show