Model #77-TYPE 14 Skil saw circular

  • Unit Parts
    3 Results

Question and Answers

Q:

I have a Kenmore Elite 70 pint dehumidifier model 251.90701 and the temperature is always 77 - 80, yet the ambient air is not that hot? What's right?

A:

That ambient temperature reading on the dehumidifier is measured by a sensor inside the dehumidifier. That temperature sensor may not be accurate. You did not indicate the actual ambient temperature that you are measuring at the dehumidifier. If the temperature is only off by a few degrees, this could be normal. If the temperature is off by 10 degrees or more, then you may want to have the dehumidifier checked by a technician if it is under warranty. Call 1-800-4MY-HOME (1-800-469-4663) regarding warranty service.

Read More
Lyle W -
Sears Technician
September 27, 2011
Q:

Craftman 14 inch chainsaw

A:

We are not going to have that type of fuel line information for the chainsaw. The carburetor replacement is not intended to be performed as a do-it-yourself repair. If you examined and documented the placement of the fuel lines when you removed the original carburetor, then the fuel lines should normally be replaced in the same order on the replacement carburetor. Since the carburetor is a substituted part, it will likely be connected in the same manner. I recommend that you take the chainsaw into a Sears Repair Center and have a technician install the carburetor. Here is a link for the Sears Service website that has drop-off locations: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 09, 2010
Q:

Craftsman 14" band saw

A:

To be sure we are talking about the same pins, I am speaking of the pins (item 50) on the parts diagram. These are locater pins and tight from corrosion over the rears.

Spray the pins liberally with rust buster and tap on the pins and the housing around them with a hammer to help the rust buster penetrate.

Clamp a pair of vise grip pliers on the pins and turn them slightly as you pull them out of the old housing.

Read More
Jimmy K -
Sears Technician
May 14, 2010