Model #77-4957-45-07 TAPPAN Ranges, Electric

  • Cover Page
    3 Results
  • Cooktop Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Lower Body Parts
    3 Results
  • Broiler Parts
    3 Results
  • Drawer Parts
    3 Results
  • Control Panel
    3 Results
  • Top Door Parts
    3 Results
  • Power Control
    3 Results
  • Upper Body Parts
    3 Results
  • Splasher Control
    3 Results
Find part by diagram >

Question and Answers

Q:

Dyson DC 07 vacuum

A:

Thank you for your request for the handle release.

There has been an update to this part from Dyson

You will need to order either 908821-01 if a clutched drive assembly or 908822-01 for a clutch less model.

You can order this part from: Sears Parts Direct .

Lock .

I hope this will help.

Thank you for using Manage My Life.

Sam A.

Read More
Sam A -
Sears Technician
August 18, 2011
Q:

Why does my Kenmore dehumidifier stop working after it shuts off in comfort mode?

A:

In the comfort mode, the unit will work automatically to maintain a humidity level based on the ambient temperature that is being sensed at the unit. You did not indicate what temperature that you actually measured in the room. The temperature measured by the dehumidifier may be a few degrees off. If it is more than 10 degrees off then this would be unusual. Before deciding whether something is wrong, I recommend that you accurately measure the temperature in the vicinity of the dehumidifier with a good thermometer. Since the dehumidifier has an evaporator coil inside, it will normally cool the air in the immediate vicinity of the unit.

Try using other manual settings on the dehumidifier. See if it will operate properly. If it does, then there may be nothing wrong with it.

The dehumidifier has a self diagnostic feature. It will normally display an error code if it detects a component problem.

The remote display works off of RF (Radio Frequency) transmission. You could have RF interference that is preventing the remove from always receiving the signal from the dehumidifier even if it is in close proximity. This could be normal. If it connects most of the time then it is likely okay.

When you turn the unit off and back on, it could affect the temperature being sensed by the thermistor (temperature sensor). It may also affect the humidity being sensed. This could be normal.

I don’t have enough details to help you determine whether the dehumidifier is malfunctioning.

If the unit will not work in other modes, then it could have a problem. If you are certain that it is malfunctioning then it may need service. If it is still under warranty, follow the directions for warranty service in your owner's manual.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
September 18, 2009
Q:

Thermador PD304BS/07 won't bake above 350

A:

Thank you for your question and I understand your concern.

The first thing to check and confirm is to make sure the bake and broil elements operate. If the bake and broil elements will heat, then it could have a faulty temperature sensor or an intermittent oven control board operation.

I strongly suggest calling a service technician to diagnose and repair your range. You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 04, 2012