Model #77-4957-45-06 Tappan ranges, electric

  • Cover Page
    3 Results
  • Cooktop Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Lower Body Parts
    3 Results
  • Broiler Parts
    3 Results
  • Drawer Parts
    3 Results
  • Control Panel
    3 Results
  • Top Door Parts
    3 Results
  • Power Control
    3 Results
  • Upper Body Parts
    3 Results
  • Splasher Control
    3 Results

Question and Answers

Q:

microwave display

A:

Thank you for your question and I understand your concern.

The "F5" fault code indicates a damper switch sensing error.

I am sorry, but we do not give repair information on microwave ovens because they are inherently dangerous to service. Microwaves contain high voltage internal components that can retain a lethal electrical charge even when the microwave is completely unplugged. Door repairs and adjustments, even minor ones, can cause microwave leakage, and a microwave shielding leakage test must be performed using a survey meter after any microwave service. That's why I strongly warn you to have this repair handled only by a qualified service technician. You can schedule service online with Sears Home Services or by calling 1-800-4-MY-HOME.

Normally at ManageMyLife.com we like to help you with all of your repairs, but our expert advice is that microwaves are just too dangerous.

Read More
Joey S -
Sears Technician
May 12, 2012
Q:

Why does my Kenmore dehumidifier stop working after it shuts off in comfort mode?

A:

In the comfort mode, the unit will work automatically to maintain a humidity level based on the ambient temperature that is being sensed at the unit. You did not indicate what temperature that you actually measured in the room. The temperature measured by the dehumidifier may be a few degrees off. If it is more than 10 degrees off then this would be unusual. Before deciding whether something is wrong, I recommend that you accurately measure the temperature in the vicinity of the dehumidifier with a good thermometer. Since the dehumidifier has an evaporator coil inside, it will normally cool the air in the immediate vicinity of the unit.

Try using other manual settings on the dehumidifier. See if it will operate properly. If it does, then there may be nothing wrong with it.

The dehumidifier has a self diagnostic feature. It will normally display an error code if it detects a component problem.

The remote display works off of RF (Radio Frequency) transmission. You could have RF interference that is preventing the remove from always receiving the signal from the dehumidifier even if it is in close proximity. This could be normal. If it connects most of the time then it is likely okay.

When you turn the unit off and back on, it could affect the temperature being sensed by the thermistor (temperature sensor). It may also affect the humidity being sensed. This could be normal.

I don’t have enough details to help you determine whether the dehumidifier is malfunctioning.

If the unit will not work in other modes, then it could have a problem. If you are certain that it is malfunctioning then it may need service. If it is still under warranty, follow the directions for warranty service in your owner's manual.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
September 18, 2009
Q:

Snow blade for '06 DYT4000?

A:

Thank you for your question.

I will be happy to assist you. I searched through our fit up books. The only model snow blade I show for your tractor is model 486.24441. The models you listed for older tractors with different frames.

I hope this is helpful. Please let me know if you need further assistance on the air compressor.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 06, 2012