Model #76-8967-00-02 TAPPAN Range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Cooktop Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Drawer Parts
    3 Results
  • Lower Body Parts
    3 Results
  • Control Panel
    3 Results
  • Power Control
    3 Results
  • Upper Body Parts
    3 Results
  • Top Door Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

I am getting a F7 02 code on my kenmore electric range model # 790.4661. I have read many of the questions and answers but still need help.

A:

I understand your concern and since you have already replaced the Oven Control/Clock Timer and it' still displaying the fault codes we can assume the failure is likely the touch panel.

The "F701" fault code is likely caused by a loss of a keyboard tail connection.

The "F702" fault code is likely caused by a shorted keypad.

Since the Electronic Oven Control (EOC) has been replaced, the failure is likely the Glass Touch Panel providing you do not have a loose keyboard tail connection.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services

Read More
Joey S -
Sears Technician
November 18, 2010
Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011
Q:

I need a 30 inch high base for a 76 inch round table top.

A:

Thank you for your question on the table pedestal for the 76 inch round table.

Are you trying to find another one like what is in the picture?

This would probably have to be a custom built piece.

The base circles would need to be made up and then cut into the circles.

The support between the disks and the table top would need to be turned with a lathe.

Most of all the dinning tables that large have feet instead of a round base.

I am afraid that we do not have anything like this.

Sam A.

Read More
Sam A -
Sears Technician
December 05, 2011