Model #76-8667-23-01 Tappan range (gas)

  • Cover Page
    3 Results
  • Backguard Parts
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Door Parts
    3 Results
  • Burner Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Body Parts
    3 Results
  • Control Panel
    3 Results
  • Utility Parts
    3 Results
  • Basic Body Parts
    3 Results
  • Top And Related Parts
    3 Results

Question and Answers

Q:

What does error code 01 indicate on my HE3?

A:

With out the model number or description of the product I do not know if you are referring to your HE3 washer or HE3 dryer. Based on the Dryer listed in your home profile the 01 code is not listed. The error codes on the dryer will display as "E1, E2, and E3"

There are no error codes 01 for the HE3 dryers or HE3 washers.

The 01 is not an error code.

Resubmit your question with the model number and details for specific information.

Read More
Joey S -
Sears Technician
April 11, 2008
Q:

LG Model #LDS5811ST/01

A:

Check the child lock function to make sure that function is not enabled as shown in the first image below. You did not indicate the error code that you are seeing on the dishwasher. The second and third images show the error codes for this type of dishwasher. If you see one of these error codes, you may be able to perform some of the troubleshooting shown in those images. Be sure that you shut off the circuit breaker for the dishwasher to completely disconnect electrical power before accessing internal components. If you need more help, reply with additional details (error code being displayed) and we will try to assist you further.

Read More
Lyle W -
Sears Technician
March 07, 2011
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008