Model #76-4967-23-04 Tappan range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Door Parts
    3 Results
  • Drawer Parts
    3 Results
  • Body Parts
    3 Results
  • Control Panel
    3 Results
  • Power Control
    3 Results
  • Body Parts
    3 Results
  • Door Parts
    3 Results
  • Cooktop Parts
    3 Results

Question and Answers

Q:

Any one with the same problem with samsung washing machine WF448AAP/XAA 04

A:

I researched that part. The bottom portion of that dispenser housing is only available as a complete dispenser housing assembly (part DC97-14522A). Here is a direct link for that part: Dispenser Housing for Samsung Washer WF448AAP/XAA 04 .

Read More
Lyle W -
Sears Technician
March 24, 2012
A:

Let us know if that part fits properly if you get the chance. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
March 26, 2012
See more answers
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008
Q:

I need a 30 inch high base for a 76 inch round table top.

A:

Thank you for your question on the table pedestal for the 76 inch round table.

Are you trying to find another one like what is in the picture?

This would probably have to be a custom built piece.

The base circles would need to be made up and then cut into the circles.

The support between the disks and the table top would need to be turned with a lathe.

Most of all the dinning tables that large have feet instead of a round base.

I am afraid that we do not have anything like this.

Sam A.

Read More
Sam A -
Sears Technician
December 05, 2011