Model #74 PADDLE Sevylor inflatable

  • Sevylor 74 Paddle
    3 Results

Question and Answers

Q:

How do I replace the water paddle on my Kenmore 253.5568940B?

A:

I have included a set of illustrated instructions (See images below). These should step you through the process of removing and replacing the water actuator.

If you require further assistance please resubmit your question with more details. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
February 24, 2010
Q:

Kenmore Elite Induction Cooktop range Model 790.4290 error code 74

A:

Thank you for your question and I understand your concern.

The details you added has the correct information but it did not say to "and delete".

I provided the information below from the tech sheet for the error 74..

The error 74 implies an Internal generator communication error.(3 cook zones module / left side cook zones)

  • Check cable between filter board X13 and generator board X10.
  • Replace the filter circuit board in the 3 zones induction module.
  • Replace the generator circuit board for the left side cook zones in the 3 zones induction module.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 10, 2013
Q:

How can I replace the water paddle on my Kenmore side by side refrigerator model 253.44383406?

A:

The procedure to accessing the water dispenser paddle is shown in the image below. Be sure that you unplug the refrigerator to completely disconnect electrical power before beginning this procedure. Some Kenmore refrigerators do not have the screws at the bottom of the front dispenser panel. You may have to snap the front dispenser panel if you do not find the 3 screws at the bottom after removing the drip tray.

Once you pull the dispenser housing forward in the final step shown below, you should have access to the water paddle to that you can replace it.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
June 17, 2009