Model #735-2 Craftsman router

  • Unit Parts
    3 Results

Question and Answers


I have a Proform 735 cs treadmill. Is it worth repairing or just get a new one?


The problem with the treadmill could be the motor, controller, a weak circuit breaker, or a dry walking board.

I am sending you some instructions for testing the walking belt lubrication. It might be worth installing a new circuit breaker if the belt is ok.

I would not replace the motor or the motor controller, it would be better to replace the treadmill in my opinion.

To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at []. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

Read More
Jimmy K -
Sears Technician
July 07, 2009

porter cable tiger saw #735 repair,,replace head that holds the blade part #81 thanks


Thank you for your question.

I can understand wanting to replace the blade holder on the tiger saw.

  • You will need to remove the rubber boot #108 off the front of the saw so you can get to the screws that hold the front housing #158 onto the motor unit. This could be a challenge. But if you can peel back the boot far enough to get to the screws on the holds the housing together you should be okay.

  • Once you can get the front housing off you should be able to replace #81 blade holder.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 17, 2011

Repair Gas Range


Thank you for your question and I understand your concern.

If you have the clock stop and start knobs set correctly for manual operation and the bake glow bar igniter is not glowing, it could have a faulty oven thermostat, clock timer, clean cycle timer or just a faulty or weak bake igniter. Based on the age and price of the parts, you would be better off replacing the gas range.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

I added a link to where you can shop for a new gas range. 

Read More
Joey S -
Sears Technician
November 18, 2013