Model #73-3751-23-04 TAPPAN Ranges, Electric

  • Range-electric
    3 Results
  • Oven Controls
    3 Results
  • Control Panel
    3 Results
  • Electric Cooktop
    3 Results
  • Door
    3 Results
  • Door
    3 Results
  • Elements
    3 Results
  • Boody
    3 Results
  • Cavity
    3 Results
  • Drawer
    3 Results
Find part by diagram >

Question and Answers

Q:

Any one with the same problem with samsung washing machine WF448AAP/XAA 04

A:

I researched that part. The bottom portion of that dispenser housing is only available as a complete dispenser housing assembly (part DC97-14522A). Here is a direct link for that part: Dispenser Housing for Samsung Washer WF448AAP/XAA 04 .

Read More
Lyle W -
Sears Technician
March 24, 2012
A:

Let us know if that part fits properly if you get the chance. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
March 26, 2012
See more answers
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008
Q:

Craftsman commercial metal turning lathe, model #101.28980, purchased 4-25-73, it is in excellent condition, purchsed in '73 for $899.00. Considering selling,

A:

Thank you for your question.

Trying to figure out what the lathe is worth can be difficult.

* If as you say the lathe is in excellent condition you may be able to get $1200.00 to $1500.00 for it.

  • If you have any tooling pieces that go with it,extra head stocks, and tool cutters you may do even better.

  • It kind of depends on where you live and the type of people and retirees you may have.

  • As an example if you live in Florida with all the retirees, you may be able to get the high end.

  • I you live in a remote or country area you may only get $500.00 for it.

  • You could put it on E-Bay or Craig's list, or at least look at the sites to see what the currant prices are going for.

  • You could also put it up for bid and have a reserve for the bidders to meet which would be your lowest price you would except or also a buy it know price.

You have all kinds of options so don't be in a hurry and you will probably get much more than you paid for it. Metal Lathe's of that era, if in good condition go up in price.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
October 01, 2010