Model #72-7657-23-02 Tappan range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Cooktop Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Control Panel
    3 Results
  • Upper Oven Door Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Lower Body Parts
    3 Results
  • Upper Body Parts
    3 Results

Question and Answers

Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008
Q:

Why does the temperature control rise to 72 degrees in the timer mode on my window air conditioner?

A:

I referred to the technical information for this window air conditioner. It does not give me specific information on the operation of the temperature display or the timer mode.

I am not able to determine whether the temperature setting or the actual temperature is being displayed. If the actual temperature is being displayed, then your air conditioner could be operating normally. Even at a setting of 69 degrees, it would not be unusual for an actual temperature of 72 degrees to be measured by the air conditioner temperature probe. A few degrees above the setting would be normal.

If only the temperature setting is being displayed, then you could be experiencing a power failure to the air conditioner that is resetting the temperature to 72 degrees. The temperature resets to 72 degrees when the unit is initially turned on. The timer setting is not normally reset when a power failure is experienced. This could explain the reason for the temperature changing to 72 degrees in the timed mode.

You could have a control board issue that is causing this problem. I do not have enough specific information on this unit to give you an exact answer.

If you suspect that the air conditioner is not operating properly, I recommend getting it checked by a service technician.

Read More
Lyle W -
Sears Technician
June 11, 2008