Model #72-7657-00-02 TAPPAN Range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Cooktop Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Control Panel
    3 Results
  • Upper Oven Door Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Lower Body Parts
    3 Results
  • Upper Body Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

I am getting a F7 02 code on my kenmore electric range model # 790.4661. I have read many of the questions and answers but still need help.

A:

I understand your concern and since you have already replaced the Oven Control/Clock Timer and it' still displaying the fault codes we can assume the failure is likely the touch panel.

The "F701" fault code is likely caused by a loss of a keyboard tail connection.

The "F702" fault code is likely caused by a shorted keypad.

Since the Electronic Oven Control (EOC) has been replaced, the failure is likely the Glass Touch Panel providing you do not have a loose keyboard tail connection.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services

Read More
Joey S -
Sears Technician
November 18, 2010
Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011
Q:

Why does the temperature control rise to 72 degrees in the timer mode on my window air conditioner?

A:

I referred to the technical information for this window air conditioner. It does not give me specific information on the operation of the temperature display or the timer mode.

I am not able to determine whether the temperature setting or the actual temperature is being displayed. If the actual temperature is being displayed, then your air conditioner could be operating normally. Even at a setting of 69 degrees, it would not be unusual for an actual temperature of 72 degrees to be measured by the air conditioner temperature probe. A few degrees above the setting would be normal.

If only the temperature setting is being displayed, then you could be experiencing a power failure to the air conditioner that is resetting the temperature to 72 degrees. The temperature resets to 72 degrees when the unit is initially turned on. The timer setting is not normally reset when a power failure is experienced. This could explain the reason for the temperature changing to 72 degrees in the timed mode.

You could have a control board issue that is causing this problem. I do not have enough specific information on this unit to give you an exact answer.

If you suspect that the air conditioner is not operating properly, I recommend getting it checked by a service technician.

Read More
Lyle W -
Sears Technician
June 11, 2008