Model #72-3977-66-10 Tappan range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Cooktop Parts
    3 Results
  • Drawer Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Lower Body Parts
    3 Results
  • Control Panel
    3 Results
  • Upper Oven Door Parts
    3 Results
  • Upper Body Parts
    3 Results

Question and Answers

Q:

remington22lr model 66

A:

I see that Marc posted a link in the above response for the page on the Remington website that has the Owner's Manual links. That should help you find the manual for the Remington Model 66 rifle.

Read More
Lyle W -
Sears Technician
December 26, 2012
Q:

Craftsman bandsaw. Model # 113.244200. Part # 328923.

A:

Thank you for your question on the band saw table insert.

I am sorry that we no longer have this part available. There is not known supplier for this part.

I would suggest that you could make you own iserts with some Lexan plastic material.

It can be a little unsafe to use the saw without the insert but not dangerous.

It would be better for the saw and the project if you had the insert in place so the tear out on the back of the wood will not be so bad. Also if you are cutting very small pieces you do not want them to fall down into the gap and blade path while you are cutting.

It also helps control the flexing of the blade as you scroll around curves.

I would measure the thickness of the insert flush with the table top and make a piece of material to fit snug in the insert hole. Mark the center line for the blade and then use the saw to carefully cut the kerf in the insert so you can install it the table with the blade in place.

Please let me know what you come up with.

Sam A.

Read More
Sam A -
Sears Technician
January 17, 2012
Q:

my ignitor has 66 omhs instead of 40 omhs is this a problem

A:

Thank you for your question.

I can understand wanting the information on the igniter.

Yes, I would change the igniter if the ohms are that far off. It needs to be real close to 40 ohms or it will not get hot enough satisfy the sensor and open the gas valves.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 10, 2010