Model #72-3657-66-05 TAPPAN Range (gas)

  • Cover Page
    3 Results
  • Splasher Control
    3 Results
  • Cooktop Parts
    3 Results
  • Lower Oven Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Control Panel
    3 Results
  • Upper Oven Door Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Lower Body Parts
    3 Results
  • Upper Body Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

remington22lr model 66

A:

I see that Marc posted a link in the above response for the page on the Remington website that has the Owner's Manual links. That should help you find the manual for the Remington Model 66 rifle.

Read More
Lyle W -
Sears Technician
December 26, 2012
Q:

what does code f 05 mean

A:

The "F05" fault code indicates a Water Temperature Sensor Error. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F05" error code will be displayed. See image below for further instructions.

Potential Causes:

  1. Check the Water Temperature Sensor resistance. It should measure 9.7K ohms at 86 degrees.
  2. Check connections to the Water Temperature Sensor
You will likely find the wire connection had come loose from the temperature sensor. Without having the model number of your HE3t washer I will not be able to confirm if the heater and sensor is located at the lower backside of the tub or at the front lower section of the tub. Disconnect the power cord from the power source before removing the front lower access panel and checking for loose connections on the temperature sensor.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 04, 2010
Q:

my ignitor has 66 omhs instead of 40 omhs is this a problem

A:

Thank you for your question.

I can understand wanting the information on the igniter.

Yes, I would change the igniter if the ohms are that far off. It needs to be real close to 40 ohms or it will not get hot enough satisfy the sensor and open the gas valves.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 10, 2010