Model #70172911-79 SEARS Playground Equipment

  • Frame Assembly
    3 Results
  • Glide Ride Assembly
    3 Results
  • Slide Assembly
    3 Results
  • Swing Assembly
    3 Results
  • Trapeze Bar
    3 Results
Find part by diagram >

Question and Answers

Q:

manual for mo 358791540 manual need magnato gap clearance

A:

Thank you for the question.

I will be happy to help assist you. The air gap for the ignition module is .010-.012 inch.

Please let me know if you need further assistance on the weed wacker.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 02, 2011
Q:

kenmore elite dishwasher stuck with blinking light over "Quick Rinse" button. time window shows "79" or a couple of dashes. won't cancel or start. how reset?

A:

There is not a reset key sequence for the stuck key fault code that you are seeing but you can try this:

  • Shut off the breaker for the dishwasher for about 5 minutes. This will completely power down the control board inside the dishwasher. When you reset the breaker and the dishwasher powers back up (reboots), it may reset and the control may work normally. This has a slim chance of working but it is worth a try.

If the above routine does not work, you will likely need to replace the control console touch pad assembly to fix this problem. In some situations, you may also need to replace the electronic control board. This is a fairly basic repair that you may be able to complete yourself if you are willing to try it. Since I don't have the model number for your dishwasher, I cannot provide definite procedures or part numbers for this fix. The image below shows the basic procedure for replacing the control board on a typical Kenmore Elite dishwasher like the one that you are describing. The control board may not have to be replaced but the control panel/touchpad for the dishwasher almost certainly will. If you want to attempt this type of repair yourself and need more help, submit your model number and we will assist you further. NOTE: Be sure to shut off the breaker to disconnect electrical power from the dishwasher before accessing internal components as shown below.

Read More
Lyle W -
Sears Technician
August 28, 2010
Q:

This is a Craftsman lawn tractor model 917 255370. Parts direct sent belt number STD324830 which seems to be about 3 inches to long. The old belt was 79 3/4", the new one is 83". This is the recommended substitute. How do I install to fit?

A:

You can't make the belt fit if it is 3 1/4 inches longer than the original.

If you are sure you measured correctly and part of the original belt did not fall off, get parts direct to send you another belt.

Read More
Jimmy K -
Sears Technician
July 15, 2009