Model #6-S (701010 - 701899) Briggs & Stratton engine

  • Cylinder,base,piston,connecting Rod,crnkshft,flywheel Parts
    3 Results
  • Fuel System, Blower Case And Magneto Parts
    3 Results
  • Gear Reduction And Starter Parts
    3 Results

Question and Answers

Q:

whats wrong with my washer when all auto temp lights are on and three 6's in time area

A:

I understand your concern. I added an image below with the instructions on Reading Error Codes. Three 6's is not a valid fault code. The information I added in image below should assist in reading Error Codes. If you need any additional information, reply with the complete model number and the error code.

Read More
Joey S -
Sears Technician
November 15, 2010
Q:

Why is my wall oven unit model 278311890 (80's model) flashing " - 6 F" from right to left?

A:

The F6 error code that you are seeing on this model of Kenmore range indicates that the time keeper circuit in the electronic oven control board has failed. The oven control will not operate with this failure. The electronic oven control board (clock) would normally need to be replaced. This part is no longer available. I recommend looking for a replacement for this range.

Read More
Lyle W -
Sears Technician
Q:

kenmore s/s fridge

A:

I don't have an illustrated procedure or video that replacement of that cold control thermostat in your Kenmore refrigerator. The parts diagram of the control section is shown in the image below. You will need to rely on that parts diagram and your personal observation of the control area to determine how to complete this repair. Unplug the refrigerator to disconnect electrical power before beginning this repair. Safely store the food if necessary. You can look for screws under that control housing that will release it so that it can drop down. Once you release that control housing, you should be able to remove the wiring from the old cold control thermostat and pull it out. Observe how the sensor is positioned as you pull the old thermostat out. You will need to route that sensor for the new thermostat in the same manner.

I hope that this information helps. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 12, 2011