Model #68-2543-80 Magic Chef free standing, gas

  • Control Panel
    3 Results
  • Control Panel Page 2
    3 Results
  • Top Assembly
    3 Results
  • Top Assembly Page 2
    3 Results
  • Body/oven
    3 Results
  • Body/oven Page 2
    3 Results
  • Gas Controls
    3 Results
  • Gas Controls Page 2
    3 Results
  • Door/drawer
    3 Results
  • Door/drawer Page 2
    3 Results

Question and Answers

Q:

what is errcode f 68

A:

I'm sorry that your having a problem with your Oasis washer. I have confidence that you can likely repair it yourself following the instructions I added in the images below.

The "F68" or "F1" fault code indicates the Pressure Signal is Out-of-Range. The can be caused by restricted or pinched pressure switch tube or a faulty machine/motor control board. You will need to check the pressure switch tube from where it connects to the machine/motor control board down to where it connects on the lower side of the tub. If the pressure switch tube is not pinched or restricted, replace the machine/motor control board. Note: Disconnect the power cord before servicing your washer. I added the instructions in the images below on how to access the pressure switch tube.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
October 08, 2010
Q:

Kenmore air conditioner model 70121. no sounds

A:

The control board could be locked up. Try unplugging the air conditioner for 10 seconds and then plug it back in and see if it works. This may reset the control board. If the air conditioner still won't work then you will need to return it to the store or have it serviced under warranty. You can call 1-800-469-4663 (1-800-4MY-HOME) to arrange warranty service. Some smaller window units would need to be carried into a Sears Repair Center for warranty service. The agent at the phone number above should be able to tell you whether it needs to be carried in for service.

Read More
Lyle W -
Sears Technician
July 14, 2010
Q:

Should there always be about 6-8 inches of water in the bottom of my water softener?

A:

The water softener leaves water in the bottom of the salt tank to turn the salt to brine water for the next regeneration cycle. The normal depth of the water is around 2-2 1/2 inches. If you have 8 inches you should clean the nozzle/venturi.

The information for cleaning the nozzle/venturi is in the owner's manual. You can download, print, or view a copy of the owner's manual free at [www.managemylife.com].

I am sending you an image with instructions for cleaning the nozzle/venturi.

Read More
Jimmy K -
Sears Technician
March 30, 2010