Model #66517002400 Kenmore dishwasher

  • Frame And Console Parts
    3 Results
  • Inner Door Parts
    3 Results
  • Tub Assembly Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Dishrack And Water Feed Parts
    3 Results
  • Lower Dishrack Parts, Optional Parts (not Included)
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My Kenmore dishwasher doesn't complete all the cycles. Water is left in it and I have to push the cancel/drain button twice.

A:

Hi Daphne,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your dishwasher.

Jackie S provided you with a couple of links that may help with your issue. In the second one above Joey S provided some really good advice for this type of dishwasher. There is a good possibility the blockage is inside the check valve fitting. This is the fitting that the drain hose is connected to at the pump.

  1. Disconnect the power to the dishwasher.
  2. Remove the lower toe panel by removing the screws securing it to the frame.
  3. Remove the drain hose clamp and remove the drain hose from the pump. NOTE: Be sure to remove all the water first and have a towel handy.
  4. Remove the drain fitting from the sump by turning it counterclockwise (CCW).
  5. Check and clean out any debris from inside the port of the sump where the drain fitting was screwed into and any debris inside the check valve fitting.
  6. Reverse the procedure, reconnect electrical power and recheck the drain operation.

I have provided an image below that will demostrate the location of this check valve.

I hope this is helpful. Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
May 24, 2011
Q:

: 66517002400 why does my dishwasher flash 7 times pause then flash 7 again?

A:

Thank you for your question and I understand your concern.

You did not indicate which LED's are flashing. According the model number provide, the dishwasher flashing 7 times is not listed as a fault code. I added an image below with a list of possible faults and the causes.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 10, 2012
Q:

66517002400 why does my dishwasher flash 7 times pause then flash 7 again?

A:

Thank you for your question and I understand your concern.

You did not indicate which LED's are flashing. According the model number provide, the dishwasher flashing 7 times is not listed as a fault code. I added an image below with a list of possible faults and the causes.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 10, 2012

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show