Model #66513462K900 Kenmore dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain, And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Lower Washarm Parts
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore D/W lights (quick rinse, cancel, normal wash) constantly flash but D/W doesn' start. Is malfunction due to touch pad or electronic control?

A:

Thank you for your question.

Usually when this happens, it is because one or more buttons on the console are shorted. I have posted an image below that has a test you can do to determine the problem.

  1. First, turn the power off to the dishwasher.
  2. Access the unit control by removing the screws in the inter door panel.
  3. Remove the P1 ribbon cable that goes to the touch pad.
  4. With that wire off reassemble the door and restore power.
  5. Wait five seconds after restoring power and close the door.
  6. If the drain motor runs the touch pad needs to be replaced.
  7. If it does not do anything the unit control is defective.

The parts can be ordered from our parts website: Sears Parts Direct .

If you need further assistance, please reply to this post. I will be happy to assist you.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 13, 2011
A:

Thank you for your question.

Usually when this happens, it is because one or more buttons on the console are shorted. I have posted an image below that has a test you can do to determine the problem.

  1. First, turn the power off to the dishwasher.
  2. Access the unit control by removing the screws in the inter door panel.
  3. Remove the P1 ribbon cable that goes to the touch pad.
  4. With that wire off reassemble the door and restore power.
  5. Wait five seconds after restoring power and close the door.
  6. If the drain motor runs the touch pad needs to be replaced.
  7. If it does not do anything the unit control is defective.

The parts can be ordered from our parts website: Sears Parts Direct .

If you need further assistance, please reply to this post. I will be happy to assist you.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 13, 2011
See more answers