Model #66513443K900 KENMORE dishwasher

  • Frame And Console Parts
    3 Results
  • Inner Door Parts
    3 Results
  • Tub Assembly Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Dishrack And Water Feed Parts
    3 Results
  • Lower Dishrack Parts
    3 Results
  • Optional Parts (not Included)
    3 Results


Error Codes

Error Code:



Question and Answers


MY DISHWASHER NEED A PART can you determine what this is?


Hi Marlene,

Thank you for submitting a question to Manage My Life.

I am unable to determine which part this is with the images you sent. If the part you need came from the bottom of the tub on the right hand side it is the High Limit thermostat (part number 661566). If the part you need came off of the bottom of the sump assembly (see image below) that is the thermistor (part number 8193776).

Also the thermistor wires are grey with an orange stripe and white with a violet stripe. The high limit should have orange and a white with a red stripe.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram and for parts purchases; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance, include more details, in a reply to this post.


Read More
Landell -
Sears Technician
November 13, 2011

Kenmore dishwasher 665.13443K900 not working/no power 66513443K900 Kenmore Dishwasher


Thank you for your question and I understand your concern.

There are two things to check; the electrical supply wire connections behind the electrical junction box cover located under the front of the dishwasher. NOTE: Flip the house circuit breaker off dedicated for the dishwasher before removing the electrical junction box cover. Remove the two plastic wire nuts connecting the black and white wires. You may find a loose or burnt wire connection. If the connections are good and no signs of it overheating, the next step is to measure and verify the proper voltage across the black and white wires on the electrical supply. If the voltage is correct (120), the next thing to check is the thermal fuse behind the console panel. If the thermal fuse is faulty/open, the dishwasher will not power up. The thermal fuse is connected in a series circuit between tan wire of the door switch and the tan wire connected to the control board. You can disconnect the thermal fuse and check it for continuity with an Ohm meter. Be sure to flip the house circuit breaker off before removing the control panel. Remove the screws directly behind the control panel to remove the control panel. The thermal fuse kit #675813 for model 665.13443K900 can be ordered at Sears Parts Direct. Be sure to install the new harness and install the shield along with the new thermal fuse.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
September 28, 2012

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show