Model #66513123K701 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump, Washarm And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

I have a kenmore elite dishwasher. Soap dispenser latch is broken so I ordered a replacement part. How do I remove the old one and install the new one?

A:

Thank you for your question and I understand your concern.

I assume you purchased the detergent dispenser assembly because just the latch is not available. 

I added a video showing the procedure of accessing, removing and installing the detergent dispenser assembly. 

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
August 30, 2013
Q:

why is dishwasher elite model #66513123k701 not draining.

A:

Hi Conrad,

Thank you for submitting a question to Manage My Life. I know how frustrating it can be when appliances do not function properly.

Most likely this is caused by something restricting the water flow. The sump will normally have about 2.4 cm (1 inch) of (clean) water remaining after cycle. First I recommend checking the drain lines. Check the drain loop, the check valve may not be sealing. Disconnect drain hose at plumbing connection. Elevate hose above dishwasher and fill with water. If water flows into dishwasher, replace entire drain loop, (install as high as possible and attach to underside of countertop if possible).

Check the sump assembly for restrictions from clogs. I have included the disassembly instructions for this dishwasher in the images below.

If no restrictions are found in the sump or drain lines, perform the service cycle diagnostics with error codes and see if there are any error codes stored. . Be sure to record any failures and when they occur along with any error codes that are displayed.

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram and for parts purchases; Sears Parts Direct .

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
October 02, 2011
Q:

Please email me the tec sheet that is inclosed in panel of my kenmore elite ultra wash dishwasher. model# 66513123k701. Water isn't heating .

A:

Thank you for your question and I understand your concern.

I added a couple of images below with the technical data requested. The information I provided should assist the technician it diagnosing the failure.

Read More
Joey S -
Sears Technician
May 06, 2011

Top Parts