Model #640-106145-113 Char-broil grill, gas

  • Gas Grill
    3 Results

Question and Answers

Q:

tablesaw mod # 113 . 226640 out of square 113 . 226640

A:

Thank you for your question on the table miter slot not square with the saw blade.

If you have used a sliding miter square in the groove of the miter slot and slide the square up against the blade on a tooth that is pointing to the left at the back of the blade slot. Then move the same tooth forward and slide the square forward and if it is off the 64th as you mentioned you may be able to get it to true up by loosening the trunnion motor mounting screws and see if you can move which ever end is off and re-tighten the screws.

There is not much of a adjustment for this problem, so make sure you blade is true and the motor are is not bent.

Please let me know if you could get enough movement to true the blade to the miter slot.

Sam A.

Read More
Sam A -
Sears Technician
October 01, 2012
Q:

113 177490 wet vacuum

A:

Thank you for your question.

I can understand your question as to whether to remove the filter or not when vacuuming water.

  • To be on the safe side I would remove the filter, so you eliminate the possibility of damaging the filter.

I have giving you the recommendations from the page in the owners manual that you can use to make your decision as to taking the filter or leaving it in.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 06, 2010
Q:

The adapter vent tube #318317100, for built in electric oven #79040522(640 or 400):

A:

That part is shown in the image below. It fits over the exit vent for the oven cavity. It will slightly reduce the flow of air and smoke out of the oven during the bake mode, broil mode or self clean cycle. If that part has fallen out of the oven, then you may be able to insert a new one yourself. I don't have specific information on how to replace that component. You may be able to push it into place from inside the oven cavity. If not, then you would need to shut off the house circuit breakers for the oven to completely disconnect electrical power and pull the oven out of the cabinet. You would then need to disassemble the top of the oven to access that vent tube and the top of the oven cavity. I don't recommend that you attempt that type of repair yourself. Here is a link for the Sears Service website: Sears Home Services .

You should be able to run the self clean cycle with that component missing. I recommend that you clean out any excessive spills before running that self clean cycle. You may notice more smoke coming out of the oven during that self clean cycle. You will need to adequately ventilate your home and protect your pets and birds during that cycle. I do not know of any danger that would be caused by operating the oven normally without that vent adapter in place. I do recommend that you replace it (or have a service technician replace it) as soon as possible. If you can wait until you replace that component before running the self clean cycle, that would be better.

I hope that this information helps. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
December 05, 2011