Model #640-05861277-1 Kenmore grill, gas

  • Gas Grill
    3 Results

Question and Answers

Q:

The adapter vent tube #318317100, for built in electric oven #79040522(640 or 400):

A:

That part is shown in the image below. It fits over the exit vent for the oven cavity. It will slightly reduce the flow of air and smoke out of the oven during the bake mode, broil mode or self clean cycle. If that part has fallen out of the oven, then you may be able to insert a new one yourself. I don't have specific information on how to replace that component. You may be able to push it into place from inside the oven cavity. If not, then you would need to shut off the house circuit breakers for the oven to completely disconnect electrical power and pull the oven out of the cabinet. You would then need to disassemble the top of the oven to access that vent tube and the top of the oven cavity. I don't recommend that you attempt that type of repair yourself. Here is a link for the Sears Service website: Sears Home Services .

You should be able to run the self clean cycle with that component missing. I recommend that you clean out any excessive spills before running that self clean cycle. You may notice more smoke coming out of the oven during that self clean cycle. You will need to adequately ventilate your home and protect your pets and birds during that cycle. I do not know of any danger that would be caused by operating the oven normally without that vent adapter in place. I do recommend that you replace it (or have a service technician replace it) as soon as possible. If you can wait until you replace that component before running the self clean cycle, that would be better.

I hope that this information helps. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
December 05, 2011
Q:

I hve Sears Snow Blower Mod 536.886440 that need impeller spring pin. Part 454565 is wrong as it is 1/4 inch when 1/8 inch is needed. How do I get right part?

A:

To get the correct spring pin for the impeller on your snow thrower look on the page that says "frame assembly" but is really the gearbox and impeller. The spring pins are item 341. The part number is STD572512 and the cost is $2.16 for a package of 2 pins.

The part number 454565 should cross over to STD572512. I think someone picked up the wrong package when your order was filled. If you order the STD572512 you should get the right pins.

Read More
Jimmy K -
Sears Technician
May 20, 2010
Q:

My Sears Kenmore Dryer, Model # 11064602300 runs fine, but no heat.

A:

Hi Glenna,

Thank you for submitting a question to Manage My Life.

Here is a link to a previous question on the same kind of dryer with this issue; My Kenmore dryer is not heating. Would it be hard to fix? . Follow Lyles troubleshooting in his answer to this question.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. Check the things covered here, and if I may be of further assistance, include more details in a reply to this post.

Landell

Read More
Landell -
Sears Technician
January 23, 2012