Model #6270 DIRT DEVIL Vacuum, Upright

  • Frame Assembly
    3 Results
  • Wiring Schematic
    3 Results
Find part by diagram >

Question and Answers


What year was my washer made model # WCRE6270K2WW Serial TS13790IG and what can I do about the squeaking sound it makes when running a cycle? GE


Thank You for contacting

I understand your concern about the squeaking noise coming from your washer. Could you please give me more details about the squeaky noise you are hearing. Does it happen through-out the entire cycle or only in spin cycle?

After researching this model I show that it was introduced in 2007.

I look forward to working with you.
Thanks for using
Read More
Desirea -
Sears Technician
October 08, 2013

My washer makes a creaking noise when it agitates in both directions. What could the problem be? WCRE6270G0WW Ge Washer


Thank you for your question and I understand your concern.

The creaking noise could be emitting from the suspension rod sockets or possibly from the shaft and mode shifter assembly. Also, check and make sure the shipping rod was removed. The shipping rod is a long metal rod that should have been pulled out from the lower right side of the cabinet. If this shipping rod was not pulled out, it could be causing the creaking noise.

I add an image below showing how to remove the front and top panel. NOTE: Disconnect the power cord from the power source before servicing.  After removing the top panel you will see the tops of the 4 suspension rods and socket that support the tub assembly. The suspension rod sockets may need a little lubricant. You should see plenty of access lubricant which can be used and spread over the contact points of where the upper parts of the suspension rods are hung. If you just open the lid and move the basket/tub around, you may hear the same creaking noise which is likely emitting from the top of the suspension rods or down at the bottom of the suspension rods. If it only makes the noise when agitating, the noise is likely emitting from the mode shifter and shaft assembly and it would have to removed and replaced. If so, I highly recommend calling a service technician to remove and replace the mode shifter and shaft assembly.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
October 02, 2013

Thank you so much. I suspected the suspension system, but didn't know about the mode shifter. That's why I asked a pro. Thanks again. Respectfully, Otis Edwards

Read More
Otis -
October 03, 2013
See more answers

What is wrong with my GE modle WCRE6270D0WW washer when it won't spin?


The washer will not spin but you move the tub back and the belt starts turning.

You don't mention anything about the agitation cycle. If the motor will agitate then most likely the motor is okay. You say the basket doesn't spin and the motor and belt don't move until you move the tub and put slack on the belt.

If the motor starts to run when you put slack on the belt it's possible the no spin problem is caused by a locked up spin bearing.

If the motor won't turn until you put slack on the belt then most likely the spin bearing is bad.

If the motor will agitate but won't spin even with slack on the belt then the no spin problem can be caused by the control or lid switch.

The image below contains the wiring diagram for this washer and the instructions for entering and running a diagnostic cycle. If you enter the test you can check each component of the washer.

Try this test and if you need further assistance then submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
July 15, 2009

Recommended maintenance parts & accessories

Show 3 more
No more item to show