Model #625348460 Kenmore water softener

  • Softener Assembly
    3 Results
  • Brine Valve Assembly
    3 Results
  • Valve Assembly
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

how to get softner working again? 625348460 Kenmore Water softener micromax

A:

Thank you for your question on the water softener not regenerating.

I believe that 78 thru 82 are verturi parts.

I would first suggest that you remove the water flow sensor (96)and then use a sewing needle and put it in the hole where the sensor was and turn the water on so see if the needle will wiggle with the water flowing.

If it does then we know that the water turbine is working. If it does not then I would suggest checking the connections for the wire harness for the sensor at the control board and also check the other connections to the drive motor on the valve.

If they appear to be good then you will need to push the bypass valve and then remove the bypass from the softener and reach to see if the turbine will spin freely or if it is damaged and needs to be replaced.

If it spins freely then it could be the sensor not picking up the effect of the magnets on the turbine.

Please let me know what you find out and I will be happy to help you further.

I will also give you the link to the interactive Kenmore water site for help in diagnosing the problem.

Kenmore water troubleshooting .

Thank you.

Sam A.

Read More
Sam A -
Sears Technician
December 10, 2012