Model #59673502201 Kenmore bottom-mount refrigerator

  • Handles & Trim
    3 Results
  • Left Refrigerator Door
    3 Results
  • Right Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Ref Dr Storage & Center Hinges
    3 Results
  • Controls
    3 Results
  • Water Dispenser/filter
    3 Results
  • Refrigerator Shelving
    3 Results
  • Interior Cabinet
    3 Results
  • Freezer Shelving
    3 Results
  • Evaporator Area & Rollers
    3 Results
  • Compressor
    3 Results
  • Cabinet Back
    3 Results
  • Ice Maker 61005508
    3 Results
  • Supplemental Information
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Thank you for step-by-step instruction to replace ice maker for Kenmore refrigerator #59673502201, plus please verify complete ice maker part/model #..

A:

The part number for the ice maker assembly for that refrigerator is D7824706Q. You can order that part from the Sears PartsDirect website.

Unplug the refrigerator to disconnect electrical power. The ice maker assembly is attached to the side wall of the freezer with screws. Remove those screws and pull the assembly away from the wall. Unplug the wiring harness. Remove the cover from the old ice maker and place it in the module if the replacement ice maker does not have a cover. Plug the new ice maker wire harness in and mount it to the wall in the freezer.

If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
June 13, 2011
A:

I provided a wiring diagram for your refrigerator and the technical information for that ice maker in the images below. I recommend that you carefully use an INSULATED jumper wire to initiate a test cycle on the ice maker. If the ice maker will not cycle, you could have a voltage supply problem. If the ice maker cycles but does not fill, you could have a problem with the water valve or the water line. Be sure that you UNPLUG the refrigerator before accessing internal components. These tips may help you with this ice maker problem. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
June 15, 2011
A:

Here are more pages.

Read More
Lyle W -
Sears Technician
June 15, 2011
A:

Here is the final page.

Read More
Lyle W -
Sears Technician
June 15, 2011
A:

I provided a wiring schematic and a wiring diagram for that refrigerator in the first image below. The door switch needs to be closed to get the 120 volt reading at the ice maker. I provided a photograph of the wire harness on the ice maker in the second image below. If you are getting voltage to the ice maker, then the fuse that is circled in that second image could be blown. I recommend that you use extreme caution when conducting the live voltage checks. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
June 17, 2011
A:

Since you heard the water valve humming when you jumped the L and V contacts, that water valve was definitely getting voltage. Check the water line from the secondary water valve to the ice maker. Make sure that the water supply line to the ice maker is not clogged. Check the inlet fill tube in the freezer to make sure that it is not frozen. You may want to blow some air through that water fill tube from the secondary water valve to the ice maker to make sure that it is clear. If that water line is clear, you will probably need to replace that secondary water valve to fix this problem. The refrigerator has 2 water valves. Since the water dispenser is working, it is likely that the primary water valve is working correctly. You can access the secondary water valve by UNPLUGGING the refrigerator and removing the bottom rear service panel on the back of the refrigerator. Check the wiring connections on that valve before replacing it. If the valve is apparently bad, you can order a new valve from the Sears PartsDirect.com website. Click on the FIND PARTS link at the top of this page to access that website. The part number for the secondary water valve is 12002193. I provided an instruction sheet for that water valve replacement kit in the images below. You should receive a hard copy of that instruction sheet with the valve replacement kit. Use the procedure on the second page to replace that valve assembly in your bottom mount refrigerator. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
June 27, 2011
A:

NOTE: Be sure that you UNPLUG the refrigerator before accessing internal components.

Read More
Lyle W -
Sears Technician
June 27, 2011
See more answers

Recommended maintenance parts & accessories

Show 3 more
No more item to show