Model #58054701400 KENMORE Dehumidifier

  • Outer Case/control Parts
    3 Results
  • Cycle Parts
    3 Results
  • Compressor Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I install an optional drain (part number 5214A20027A) on dehumidifier model 58054701400?

A:

The image below shows the procedure for installing the optional drain hose connector in this model of dehumidifier. When you push the drain hose connector into the fitting on the dehumidifier, the fit will normally be extremely tight. It will take significant force to push the drain hose connector in properly. Make sure that it is pushed in properly so that it does not leak.

Read More
Lyle W -
Sears Technician
July 07, 2009
Q:

DEHUMIDIFIER MODEL 58054701400 RECEIVED MAIN PCB BORD, PART MISSING RY-S/VALVE THAT CONTROLES REVERSING COIL DO I NEED IT

A:

The part number for the replacement control board for dehumidifier model 580.54701400 is 6871A10141D. Make sure that you have the correct part number. A photograph of that control board is shown in the image below. Your control board should look like that one. Make sure that you have the correct part. If you do not have the correct control board, I recommend that you return that control board and reorder it. From your details, it sounds like you are indicating that your control board does not have the relay for the reversing coil. There is a chance that the reversing coil relay was eliminated from the control board due to a revision of the control board. Some dehumidifiers do not use a reversing coil. When excessive frost is detected, the compressor is shut off and the fan runs to defrost the evaporator. If you have the correct part, you can try running the dehumidifier without that reversing coil connection plugged into the control board. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
March 04, 2011

Top Parts