Model #580752700 CRAFTSMAN Power Washer, Gas

  • Main Unit
    3 Results
  • Pump
    3 Results
Find part by diagram >

Question and Answers

Q:

580752700 Pressure washer 580752700 Craftsman Pressure washer

A:

I posted an image of the linkage below. That should help you connect the throttle and governor.

Read More
Lyle W -
Sears Technician
October 30, 2013
Q:

Power washer doesn't unload pressure 580752700

A:

Check the inlet for the unloader for a clog. Installing the unloader kit normally fixes your problem when the pressure builds up as you are describing. Since you replaced the unloader and you still have problems, I recommend checking the unloader again for a clog.

Read More
Lyle W -
Sears Technician
June 03, 2015
Q:

I have a pressure washer model 580752700. It will only start with starting fluid. What is wrong?

A:

If the engine starts with starting fluid, the engine has fire and compression. This means the fuel is not getting to the engine through the carburetor.

Remove the fuel line from the carburetor and let the gas run into a container for 1-2 minutes. If there is a problem in the fuel line or the filter in the fuel tank, the fuel will stop running.

If the fuel runs a full stream for 2 minutes, the carburetor is stopped up inside. You can rebuild the carburetor or replace it. The part number for a new carburetor is 499059, and the price is around $55.00. The carburetor overhaul kit is part number 498260 and the price is around $12.00.

If you overhaul the carburetor you need to spray carburetor cleaner through all the fuel and air passages inside the carburetor and blow them out with compressed air. To clean the passages you need to run a soft wire through them, spray carburetor cleaner through them, and then blow compressed air through them.

Read More
Jimmy K -
Sears Technician
March 18, 2009

Top Parts