Model #56-8482-10-01 Tappan countertop microwave

  • Non-ilustrated Parts
    3 Results
  • Control Panel
    3 Results
  • Door Parts
    3 Results
  • Wiring/functional Parts
    3 Results
  • Wrapper And Body Parts
    3 Results

Question and Answers

Q:

refrigerator laid down during transit. left upright for 24 hrs without plugging in and told to plug in for 3 min unplug for 10 (5-6 times) correct info?

A:

The refrigerator should be left upright for 24 hours after being laid down for transit. After 24 hours you can plug the refrigerator in and leave it turned on.

When a refrigerator is laid down for transit, some of the oil will run out of the compressor into the evaporator and suction line. Twenty four hours is adequate time for the oil to run back into the compressor.

Read More
Jimmy K -
Sears Technician
July 09, 2010
Q:

Kenmore elite dryer not starting

A:

Hi Jim,

Thank you for submitting a question to Manage My Life.

You did not mention any beeping. Typically when these dryers will not start and you get 3 beeps when start is pressed it is because the door switch is bad. I am including the diagnostics for the door switch and thermistor in the images below. Check the door switch, thermistor, and see if the dryer will declare an error code.

You did not mention which circuit board you replaced I assume it was the main control (part number 8557308). Other possibilities;

  • 1 Console
  • 2 Wiring harness


If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance, include more details in a reply to this post.

Landell

Read More
Landell -
Sears Technician
March 02, 2012
A:

Jim,

Did you ohm your thermistor? I am including the entire tech sheet for this dryer in the images below. Perform test # 3a the Thermistor Test (PAGE 6) and test # 2 Motor Circuit Test (PAGE 5). The motor test will show you how to ohm the motor.

Check the things I have covered here, and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
March 05, 2012
See more answers
Q:

Follow up to "no spin problem" WFMC2100UC/01

A:

After the installation, the E:04 indicates "Door control broken". The E:20 indicates "Spinning aborted due to unbalanced load". The d:08 indicats "motor speed sensor failed." The d:10 indicates "Power limiter switch tripped." The E:09 indicates that communication was lost to the motor. 

I recommend that you have a service technician examine and repair this washer.

If you want to continue to troubleshoot the problem yourself, I recommend that you check the wire harnesses for damage and connection problems first. You may also have a defective speed sensor, bad control module or failed motor control.

If you need further assistance, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
March 23, 2015