Model #56-2268-10-16 Tappan countertop microwave

  • Front Cover
    3 Results
  • Control Panel
    3 Results
  • Door Parts
    3 Results
  • Functional Parts
    3 Results
  • Wrapper And Body Parts
    3 Results

Question and Answers

Q:

16" saw

A:

Thank you for your question.

I can understand wanting to know who made the chain saw.

The 358. prefix in the model number tells me that it is a Craftsman model manufactured by Poulan.

If there is anything else I can help you with on you chainsaw please reply.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 28, 2011
Q:

refrigerator laid down during transit. left upright for 24 hrs without plugging in and told to plug in for 3 min unplug for 10 (5-6 times) correct info?

A:

The refrigerator should be left upright for 24 hours after being laid down for transit. After 24 hours you can plug the refrigerator in and leave it turned on.

When a refrigerator is laid down for transit, some of the oil will run out of the compressor into the evaporator and suction line. Twenty four hours is adequate time for the oil to run back into the compressor.

Read More
Jimmy K -
Sears Technician
July 09, 2010
Q:

Ref Craftsman 10" Radial Arm Saw Model Number 113.23100 Schematic diagram Part number 16 and 41 -- How do they connect ?

A:

Thank you for your question on the radial arm saw arm movement and not holding while cutting.

The locking parts on the end of the locking rod has a depression to hold the locking pin that goes into the 90 and 45 degree lock stops.

If it is not holding in those locations the pin is not engaging into the 90 and 45 notch on the column.

These can get rusted over time and not move in and out when you pull the lever at the front of the arm.

You may want to work some spray lubricant into that area to loosen those parts.

Number 41 is the lock stops on the column and number 16 is the pin that locks into 41 at the 90 and 45 position.

It has to move in and out of the lock positions buy pulling on the front handle. Number 17 is the link between number 16 and the front handle adjustment.

There is a brake pad that is used for the non 90 and 45 degree positive stops. And when you push and pull on the handle it will release or apply the brake to hold the arm in the other degrees of cut.

If you turn the front knob you have put more or less pressure on that brake pad to hold the arm in position.

I hope this information will help.

Sam A.

Read More
Sam A -
Sears Technician
April 07, 2012