Model #5-52-20RT8-2 RELIANCE Water heater

  • Round Electric
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a Sears Garden tractor, type 5000, with a 52" cut. I am having trouble raising the deck above 1 1/2" to cut grass.

A:

Without a model number of the tractor, I don't know what kind of deck adjustments you have.

Get the correct model of the tractor from under the seat and go to [www.managemylife.com]. Enter the model number in the "manual search" field on the home page.

Look in the owners manual for the instructions for adjusting the deck and installing the deck. The deck lifting arm needs to be all the way down when the deck is installed. This will give you the full travel of the lift lever to raise the deck farther.

If this doesn't work, send another email and include the model number of the tractor. We will be glad to help.

Read More
Jimmy K -
Sears Technician
July 20, 2009
Q:

temperature of single burner on range at settings of 2 and 5

A:

Aashe is correct that the owner's manual shows information about the burner settings on page 11. The exact temperatures of the burner are not a specification that is provided by the manufacturer for the surface burners. That information on page 11 should help you when using the surface burners. The setting of 2 will normally heat the surface to just over 220 degrees. The setting of 5 will probably heat the surface to around 300 degrees. These are just ballpark estimates but they may be what you are looking for. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
September 27, 2011
Q:

wiring switch for 5 1/2 circular saw

A:

Thank you for your question on the wiring of the circular saw.

The switch number changes to a new substitute part number 606340-002.

If the new switch did not come with wiring instructions and because it is a different switch from the original I would suggest that you use a volt/ohm meter to the continuity through the switch from whether is has continuity from side to side or top to bottom.

Put your black probe on one of the terminals and the red meter probe on another terminal on the same side and pull the trigger to see if you get continuity.

Once you determine the connections in the switch then you can start with your black power cord wire to one side of the switch and the white to the other side. Remember this is a circle loop electrical circuit. The power comes from the cord into the switch and then into the motor windings and then out of the motor winding to the neutral side of the line back out of the power cord. The motor windings have to be between the hot and neutral on the power cord and the switch breaks or makes the circuit.

I am sorry but I could not find an appropriate picture to illustrate this for you.

Sam A.

Read More
Sam A -
Sears Technician
November 13, 2012