Model #536885203 Craftsman snowthrower, gas

  • Drive Components
    3 Results
  • Auger Components
    3 Results
  • Handle & Discharge Components
    3 Results

Question and Answers

Q:

I am look for primer bulb for a snow thrower model 536-885203 with a 4 cycle engine.

A:

The primer bulb for your snow thrower is no longer available for ordering.

You might find a primer bulb on the web, Sears does not have a way to order the primer bulb.

Read More
Jimmy K -
Sears Technician
November 06, 2009
Q:

replacing Tension Bushing

A:

Thank you for your question.

I can understand wanting to know how to change the tension arm bushing.

  • There is one nut that captures the tension arm onto the chassis of the snow-thrower.

  • You will have to lift the snow thrower and stand it up so you can see the head of the bolt behind the left wheel on the underside by motor mounting plate.

  • Remove the nut on the top side and slide the tension out towards the back and slide the new tension on and slide the bolt back up into the slot on the tension. You may have to reach in from the under side to push the bolt back up into the motor mount housing and then through the tension.

  • Adjust the tension so the drive cable will put some flex on the tension just enough to drive the auger, the lock the nut. .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
January 29, 2011
A:

I am sorry maybe we are talking about two different parts? I was referring to the tension for the drive cable that comes from the handle. It comes with the roller already on the end of it. I have given a picture below to see key #13 and the arm are together. And it is held in place with nut #12 and bolt#10. Please tell me if we are talking about the same part and if not could you give me a little better description so I can do a better job of helping you. Sam A.

Read More
Sam A -
Sears Technician
January 29, 2011
A:

Thank you for the update. We are talking about the same tension control. This plastic roller should just slide onto the arm, you may have to work it back and forth to get it to go on where the old one was. Once it is in place it should spin. Sam A.

Read More
Sam A -
Sears Technician
January 31, 2011
See more answers