Model #5361-1700 Craftsman snowthrower

  • Handle Assembly
    3 Results
  • Pulley And Springs
    3 Results
  • Base Assembly
    3 Results
  • Auger And Gear Case Assembly
    3 Results

Question and Answers

Q:

My riding mower is not listed and checked over 1700 pages for it

A:

Thank you for your question.

I searched for a copy of the manual on line but did not have any luck. I was able to find a manual for a tractor very similar to yours. Click here to load that manual. If this manual will not work, you can still order the original manual. The part number for the manual is 160642 and can be ordered from the following link. Craftsman tractor parts



I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage My Life!

Mark T.

Read More
Mark T -
Sears Technician
July 27, 2012
Q:

Why didn't I receive any kind of user's manual or care guide with my Kenmore 1700 steam iron?

A:

You can download or print an owners manual for your iron free at [www.managemylife.com].

The model number you sent does not run in any of our systems. Verify the model number and insert the model in the search window at [www.managemylife.com].

Read More
Jimmy K -
Sears Technician
February 10, 2010
Q:

kenmore 9114652590 range oven doesn't meet temp setting.

A:

The resistance of 1700 ohms at around 350 degrees is normal for the oven temperature sensor in this range. The resistance of that component is around 1100 ohms at room temperature. It should not read "open" at any time. At the highest temperature during the self clean cycle, the sensor should measure around 2600 ohms.

The electronic control board in the console will normally display an error code if the sensor is "open" or out of the normal range of 1000 ohms to 2800 ohms.

A problem with the wiring harness between the sensor and the control board could be causing your problem. I recommend that you shut off the circuit breaker and access the wiring connections on the control board in the console. Lift the cook top and access the control board from the back side of the console. The image below shows the wiring connection for the sensor circuit on the control board. With the sensor plugged into the wire harness connection in the oven cavity, remove the wires from the control board and check the resistance through the entire sensor circuit through pins 4 and 6 on the Sensor & Lock Switch Connector of the control board. You should measure around 1100 ohms at room temperature (75 degrees). The resistance through the circuit should be the same as the resistance measured directly at the sensor. If the resistance through this circuit is high, then you could have a problem with the wiring harness. You may need to cut off the connector at the sensor in the oven cavity and connect the wires with ceramic wire nuts.

If the sensor is okay, you could have a bad electronic control board.

NOTE: If the oven temperature is off by 35 degrees or less, you can adjust the temperature using the procedure shown on page 21 of your owner's manual. Here is a link for that manual in case you need it: Owner's Manual . Make sure that you accurately measure the temperature in the oven before you adjust it. You will need to allow the oven to preheat and then cycle on and off 4 times before checking the temperature. Take an average temperature reading over a 10 minute period to determine the actual oven temperature. Using this method of actual oven temperature measurement will help prevent an improper adjustment.

I hope that this information helps. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 26, 2010