Model #47-2707-23-01 Tappan residential dryer

  • 3 Results
  • Cabinet And Component Parts
    3 Results
  • Door, Seal And Motor Parts
    3 Results
  • Top, Control And Miscellaneous Parts
    3 Results
  • Heater And Housing
    3 Results

Question and Answers

Q:

Kenmore Oasis HE washer. Model 2707. Not working right.

A:

Thank you for your question and I understand your concern.

When the washer stops at the 17 minute mark in the rinse cycle I suspect it could have a rinse fill issue. It could be taking too long to fill and it just hasn't had time to display a faulty code. You might want check the cold and hot water supply. I would also check to see if the filter screens are restricted inside the port of the water inlet valve where the hot and cold water fill hoses connects to the back of the washer.

Generally speaking if the washer detects a problem it should display a fault code in the display window. When unit stops again, wait longer than several minutes before touching the controls and wait to see if will display a fault code.

So that's what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. If you could supply me with that information and the fault code I will be happy to assist you further. The model number is located at the back of the tub opening after opening the lid.

You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
October 26, 2012
Q:

INTERNATIONAL HARVESTER MODEL 47

A:

Thank you for your question on the timing of the older model 47 IH square hay baler.

I am sorry but I do not remember the full process for timing the baler. It sounds like you may have sheared a shear pin or the timing for the twine ties are not in time with the plunger. What I do remember that if you sharpen the knives and move the plunger of until you get a clearance between the plunger and the knives of about 5/32 of an inch it should tie the knot better.

I will give you a link for acquiring the service manual for this baler below.

IH model square baler manual .

Yesterdays tractor has the service manual for this baler . You can also call them @ 1-800-583-2651.

Thank you.

Sam A.

Read More
Sam A -
Sears Technician
May 25, 2012
Q:

417.44152400 Error Code 47

A:

That E47 code normally indicates that you have a bad door lock assembly. In rare situations, a wiring problem or a bad control board could cause that code. If you want to fix this problem yourself, then replacing that door lock assembly (part 131763202) should fix your problem. You can order that part from this page: Door Lock and Switch Assembly for Kenmore Washer Model 417.44152400 . Be sure that you unplug the washer before accessing internal components. That link for a previous answer that Marc posted in the above response shows how to replace that component.

If you suspect that you have a wiring problem or a control board failure, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 30, 2012