Model #46-2351-23-02 Tappan washers

  • 3 Results
  • Cabinet Parts
    3 Results
  • Tub Detail
    3 Results
  • Transmission Parts
    3 Results
  • Console And Control Parts
    3 Results

Question and Answers

Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011
Q:

I am installing a snow blade to lawn tractor. The muffler is in the way of the right bracket. The holes line up.

A:

It sounds like you might have the wrong snow blade for your tractor. The brackets should be made so they mount easily. Send another email with the model number of your tractor included and we will check to see if this is the correct snow blade for your tractor.

You can take the bracket to a welding shop and have it modified if that is easier for you.

Read More
Jimmy K -
Sears Technician
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008