Model #44-2417-00-01 Tappan laundry centers/combos

  • 3 Results
  • Cabinet Parts And Heater
    3 Results
  • Console, Controls And Drum
    3 Results
  • Dryer Motor, Blower And Belt
    3 Results
  • Tubs, Water Valve And Lid Switch
    3 Results
  • Washer Drive System And Pump
    3 Results
  • Transmission Parts
    3 Results

Question and Answers

Q:

You did not answer my question. Go to the page and tell me which manual I use. Is it 00 or 01?

A:

I apologize for being clear. Use the manual or the 01 model.

Read More
Jimmy K -
Sears Technician
April 25, 2008
Q:

I have a 1 year old Samsung dryer / gas that doesn't heat. I know it is getting gas and after setting a 44 minute dry cycle it counts down to 00 in five minuwh

A:

According to your description, it sounds like the dryer may be detecting that the clothes are dry and is immediately going to the cool down portion of the cycle and shutting off. You could have a disconnected wire on the moisture sensor bars or a coating of residue that is preventing the bars from detecting moisture. Those moisture sensor bars are normally located just inside the dryer door on the inlet to the lint screen. I provided an image of the moisture sensor bars on a typical Samsung dryer in the image below. I recommend that you check those moisture sensor bars. If they are coated with fabric softener and lint, you can clean them using a cloth and rubbing alcohol. If the sensor bars are clean, you can unplug the dryer and pull out the lint screen. Check the wires that are connected to the sensor bars. If you find one disconnected, then reconnecting the wire may fix this problem.

If these tips don't help, you could have a control board problem or a loose wire connection at the control board. Reply with additional details and the full model number of your Samsung dryer. We will provide more specific troubleshooting once we receive additional information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 16, 2011
Q:

Interpreting Error codes on Bosch Washer WFMC2100UC/01 Bosch Washer WFMC2100UC/01

A:

The D:08 indicates that the motor speed sensor (tachometer) failed. The D:10 indicates that the power limiter switch tripped due to the motor being overloaded or binding up. The C:01 indicates that the codes were encountered the previous cycle in the last 16 washes. 

I recommend that you unplug the washer and check the drive system again for binding. You indicated that the drum spins freely by hand (I assume with the drive belt attached to the motor). With the belt disconnected, the spin basket should spin even easier. Check for any binding or noise in the spin basket with the belt detached. The basket may not be spinning easily with a load of wet clothes in the basket.

If you find no problems in the drive system, then you may need to replace the motor.

I hope that this information helps. If you need further assistance, let us know.

 

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
March 12, 2015