Model #4422 SEARS Playground Equipment

  • A-frame Assembly
    3 Results
  • Lawn Swing Assembly
    3 Results
  • Triple Sky Glider
    3 Results
  • Mounting Bracket
    3 Results
  • Airglide Assembly
    3 Results
  • Slide Assembly
    3 Results
  • Basketball Backboard & Goal Assembly
    3 Results
Find part by diagram >

Question and Answers


Amana Gas Oven - One day working, next day not.


Having a properly working oven is a necessity. The oven not working on bake and broil is concerning. I found some information for you that I am hoping will help you with the oven. I am adding the link below to help you with your question while you wait for your expert response. It may take 24-48 hours. I do hope that this will help you with the oven.

Read More
Marc -
December 16, 2012

Try to reset the control board in the console by completely unplugging the range for 5 minutes. This will reboot the circuit board on that control. See if the oven works after you restore power to the range. If not, then you probably have a component failure.

I posted a wiring diagram in the image below with that oven circuit traced in red. Since that igniter is not glowing, you could have a bad electronic control board, a failed igniter, a bad safety gas valve or a wiring failure in that circuit. Here is a brief video that explains the ignition process in your oven: Oven Ignition Operation .

You can unplug the range and access the back of the control board by removing the upper back panel behind the console. Check the resistance through the red and white wires connected to the control board using a volt/ohm meter (with the range still unplugged ). You should measure between 40 and 400 ohms of resistance through that circuit if the igniter and the safety gas valve are both okay. If you measure OL -- open load or infinite resistance during that test, then have a bad igniter, a bad safety gas valve or a wiring failure in that circuit. You can check the igniter and the safety gas valve directly at those components for resistance. You should measure between 40 ohms and 400 ohms through the igniter. The safety gas valve should measure around 1.5 ohms of resistance. If those components are okay then you will need to check the wiring in that circuit.

If the resistance through entire oven circuit is okay when it is checked from the control board, then you probably have a bad bake relay or a failed circuit in that control board. Replacing the control board will normally fix your problem in that situation.

You can order parts from this page: Amana Range Model AGR4422VDS0 Parts . Be sure that you unplug the range before accessing internal components and replacing parts.

I hope that this information helps. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 18, 2012
See more answers