Model #436C-14 Manco gokarts/minibikes

  • Frame/wheels/top Guard
    3 Results
  • Center And Rear Bars
    3 Results

Question and Answers

Q:

Craftman 14 inch chainsaw

A:

We are not going to have that type of fuel line information for the chainsaw. The carburetor replacement is not intended to be performed as a do-it-yourself repair. If you examined and documented the placement of the fuel lines when you removed the original carburetor, then the fuel lines should normally be replaced in the same order on the replacement carburetor. Since the carburetor is a substituted part, it will likely be connected in the same manner. I recommend that you take the chainsaw into a Sears Repair Center and have a technician install the carburetor. Here is a link for the Sears Service website that has drop-off locations: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 09, 2010
Q:

Craftsman 14" band saw

A:

To be sure we are talking about the same pins, I am speaking of the pins (item 50) on the parts diagram. These are locater pins and tight from corrosion over the rears.

Spray the pins liberally with rust buster and tap on the pins and the housing around them with a hammer to help the rust buster penetrate.

Clamp a pair of vise grip pliers on the pins and turn them slightly as you pull them out of the old housing.

Read More
Jimmy K -
Sears Technician
May 14, 2010
Q:

f 14 Code

A:

The F14 code indicates that you have an EEPROM (Electrically Erasable Programmable Read-Only Memory) problem on the main control board (part 8182237R). You can try to clear this code by unplugging the washer for 5 minutes. If the code returns when you plug the washer back in, the main control board will need to be replaced.

You can order the control board from the Sears PartsDirect website. Here is a direct link for that part: Electronic control .

Unplug the washer before accessing internal components. Remove the top panel to access the control board in the washer. Note the location of the wires before removing them from the original control board (take a digital picture if necessary). Remove the wires from the existing control board and then take out the old control board. Mount the new control board and reconnect the wires. Reassemble and test the washer.

These tips may help you fix this washer problem yourself. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 27, 2010