Model #4360-83 Footedana transaxle/transmission, tractor

  • Transaxle
    3 Results

Question and Answers

Q:

I have a lt1000, model 917.272670 riding mower that wont go into gear. I have no reverse or forward. Any advice?

A:

I am assuming the gearshift won't move into any gears. If this is the case, a belt guide is holding the belt too close to the pulley on the transaxle or the engine.

When you press the clutch in, the belt should "balloon" away from the stack pulley on the mower and the input pulley on the transaxle. If the belt is touching the transaxle pulley it doesn't let the pulley back off to stop driving the gears. This prevents you from shifting gears.

Adjust the belt guide on both pulleys so there is 1/4 inch space between the guide and the back of the belt.

Read More
Jimmy K -
Sears Technician
August 26, 2009
Q:

How To Oil 38519010200 Kenmore Elite Sewing machine

A:

The service manual does NOT mention anything about oiling this machine nor does it show any specific places to oil it. I recommend oiling any mechanical parts where friction is applied or take the machine in for service.

Read More
Joey S -
Sears Technician
June 08, 2015
Q:

This is a Craftsman lawn tractor model 917 255370. Parts direct sent belt number STD324830 which seems to be about 3 inches to long. The old belt was 79 3/4", the new one is 83". This is the recommended substitute. How do I install to fit?

A:

You can't make the belt fit if it is 3 1/4 inches longer than the original.

If you are sure you measured correctly and part of the original belt did not fall off, get parts direct to send you another belt.

Read More
Jimmy K -
Sears Technician
July 15, 2009